Adjusting Reel/Auger Alarm Pressure - MacDon M2170 Operator's Manual

Hide thumbs Also See for M2170:

Table of Contents

6. Swipe the HarvestTouch

7. To adjust the auger speed, press the AUGER SPEED icon (A).

Auger speed setting (B) is adjustable between 150 and

Adjusting Reel/Auger Alarm Pressure

Adjusting the reel/auger alarm allows the operator to set an alert to inform them that the reel is operating above the

desired pressure. A lower setting will cause the alarm to be set off more often; a higher setting will allow the alarm to be

set off less frequently. This adjustment requires the header to be in operation.

1. Engage the header to display header run screen 1 or 2, and

then press REEL SETTINGS icon (A).

2. To adjust the reel pressure alarm set point, press REEL

SETTINGS icon (A) to access the REEL ADJUST page.

3. Press set point arrows (A) to set the desired pressure point

that will trigger the alarm.

The factory setting is 200 bar (2900 psi). Adjusting past the

highest setting turns the alarm off.

Display to display auger run

Figure 4.455: Auger Run Screen 2

Figure 4.456: HarvestTouch

Figure 4.457: Reel Adjust Page

Display- Header Run