MacDon M2170 Operator's Manual page 171

1. Attach the header to the windrower. For instructions, refer
to Attaching D2 Series Draper Header, page
2. Convert the header to transport mode. For instructions,
refer to header operator's manual.
3. Detach the header from the windrower. For instructions,
refer to Detaching D2 Series Draper Header, page
4. Remove hairpin (D) and clevis pin (C) securing header
support (B) to leg (A). Retain the pins.
5. Remove header support (B) from windrower lift leg (A).
6. Repeat the previous step for the opposite support.
7. Drive the windrower so that lift legs (A) are positioned in
weight box pockets (B). Raise the lift legs slightly.
8. Shut down the engine, and remove the key from the
ignition.
9. Install locking pin (C) into the pocket and secure it with
hairpin (D).
10. Repeat the previous step to install the locking pin in the
opposite leg.
262170
OPERATION
178.
Figure 4.54: Windrower with Header
191.
Figure 4.55: Draper Header Support
Figure 4.56: Windrower Lift Linkage
147
A
D
C
B
D
A
C
B
Revision A