Adjusting Reel Pressure Alarm - MacDon M2170 Operator's Manual

4. Use reel speed switches (A) on GSL to set reel speed. The
desired speed increases 1 rpm (or 0.1 mph or 0.2 km/h) per
momentary press, or continuous scrolling if switch is
pressed and held.

Adjusting Reel Pressure Alarm

The reel pressure alarm alerts the Operator that the reel is operating above the desired pressure. A lower setting will cause
the alarm to be set off more often; a higher setting will allow the alarm to be set off less frequently. This adjustment
requires that the header be engaged.
1. Engage the header to display header run screen 1 or 2.
2. To adjust the reel pressure alarm set point, press REEL
SETTINGS icon (A) to access the REEL ADJUST page.
3. Press set point arrows (A) to set the desired pressure point
that will trigger the alarm.
NOTE:
The factory setting is 200 bar (2900 psi). Adjusting past the
highest setting turns the alarm off.
262170
OPERATION
Figure 4.421: GSL
Figure 4.422: HarvestTouch
Screen
Figure 4.423: Reel Adjust Page
319
A
A
™
Display - Header Run
A
Revision A