MacDon M2170 Operator's Manual page 301

9. Connect the hydraulic hoses to the windrower as follows:
a. Connect pressure hose female coupler (A) as shown.
b. Connect return hose male coupler (B) as shown.
c. Connect case drain hose (C) as shown.
NOTE:
The case drain hose coupler will be present only if the
Low Pressure Case Drain kit (B6698) has been installed.
IMPORTANT:
Ensure that the case drain hose is connected to
port (C), NOT port (E).
d. Connect the header's electrical harness to
receptacle (D).
10. Push latch (A) to unlock platform (B).
11. Pull platform (A) toward the cab until it stops and the latch
is engaged.
12. Calibrate the header on the windrower. For instructions,
refer to 4.4.6 Calibrating Header on HarvestTouch
page 285.
262170
OPERATION
Figure 4.331: Quick Couplers on Rotary Disc Ready
Windrower with Case Drain Kit
B
Figure 4.332: Left Platform
™
Display,
Figure 4.333: Left Platform
277
C
E
D
A
B
A
A
1015478
Revision A