Installing Drive Wheels - MacDon M2170 Operator's Manual

3. Position lifting device (A) under wheel (B) as shown. Raise
the wheel slightly.
4. Remove the drive wheel.

Installing Drive Wheels

A drive wheel includes a rim and a bar or turf tire, depending on the application. A lifting device capable of supporting a
minimum of 907 kg (2000 lb.) is required to lift the wheel assembly.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
CAUTION
Use a lifting device capable of supporting a minimum of 907 kg (2000 lb.) to lift the wheel assembly.
IMPORTANT:
The windrower must be supported with stands while the drive wheels are being installed. For instructions, refer to
Drive Wheel – Jack Method, page 502
1. Shut down the engine, and remove the key from the ignition.
2. Clean the mounting surface on the wheel drive and the rim.
3. Position lifting device (A) under the wheel as shown. Raise
the wheel slightly.
4. Position the wheel against the wheel drive hub so that air
valve (B) is on the outside and tread (C) points cab-forward.
262170
MAINTENANCE AND SERVICING
Raising Drive Wheels – Forklift Method, page
or
506
Figure 5.250: Lifting Device under Drive Wheel
504.
C
Figure 5.251: Drive Wheel Ready for Installation
B
A
Raising
B
A
Revision A