Table of Contents
Advertisement
1. Park the windrower on a level surface.
2. Place the ground speed lever (GSL) in PARK.
3. Shut down the engine, and remove the key from the ignition.
4. Using a jack (or another lifting device) under the frame at
location (A), slightly raise the rear of the windrower until
most of the weight is off the casters.
IMPORTANT:
Do NOT damage the engine oil pan when raising the
windrower.
NOTE:
Lifting device must have a lifting capacity of at least
4536 kg (10,000 lb.).
5. Remove six bolts (B) (four on the backside, two on the
underside) and washers from the left and right sides of the
walking beam.
6. Slide the left and right extensions equal distances in either
the inboard or outboard directions, and align its holes at
the desired locations.
NOTE:
To assist moving the extensions, rotate the caster so the
wheel is parallel to the walking beam.
IMPORTANT:
Ensure the caster wheels are positioned at equal distances
from the center of the windrower.
262170
MAINTENANCE AND SERVICING
Figure 5.258: Left Caster Wheel Extension
Figure 5.259: Right Caster Wheel Extension
Figure 5.260: Adjustable Caster Wheels
510
B
B
B
=
=
A
Revision A
Advertisement
Table of Contents
Troubleshooting
