Replacing Headlight Bulb - Engine-Forward - MacDon M2170 Operator's Manual

2. Disconnect wiring harness (A).
3. Remove rubber insulator boot (B).
4. Remove the bulb from the body.
IMPORTANT:
Do NOT touch the glass of the halogen bulb as the oils or
other chemicals from your skin will cause the bulb to fail
prematurely.
5. Align the lugs on the new bulb with the slots in the housing
and push the bulb into place.
6. Install insulator boot (B) and wiring harness (A).
Replacing Headlight Bulb – Engine-Forward
If a headlight bulb is burnt out or damaged, it will need to be replaced.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Remove eight hex flange bolts (A), then remove headlight
bezel assembly (B). Retain the hardware.
3. Remove the electrical connectors from red tail lights (C) to
fully remove bezel (B).
262170
MAINTENANCE AND SERVICING
Figure 5.210: Front Work Light
Figure 5.211: Headlight Bezel Assembly
484
A A
C
A
A
B
A A
C
A
B
Revision A