Attaching A40Dx Auger Header - MacDon M2170 Operator's Manual

9. Lift the aft end of the forming shield and attach straps (B)
to pins (A) on the windrower frame.
10. Install washer and hairpin to secure strap. Use the middle
hole and adjust height to suit the crop.
11. Set the forming shield side deflectors to the desired width
by repositioning adjuster bars (A). Use the same hole
location on both sides.
12. Adjust rear fluffer deflector (C) to the middle position.
Loosen handles (B) if required.

Attaching A40DX Auger Header

The windrower's lift linkage and center-link will need to be connected to the header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Shut down the engine, and remove the key from the ignition.
262170
OPERATION
Figure 4.69: Forming Shield Strap
B
C
Figure 4.70: Forming Shield Adjuster Bar
156
A
B
A
Revision A