Table of Contents
Advertisement
IMPORTANT:
Ensure that the correct header supports are used:
• D2 SP Headers must use header supports (A).
• A feature that distinguishes support (A) from all other types
is that rubber block (B) is attached to the support using
pin (C).
• To order header supports, refer to the header parts catalog.
1. Shut down the engine, and remove the key from
the ignition.
2. Remove hairpin (A) from clevis pin (B) on draper header
support (C). Remove clevis pin (B).
3. Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn't snag the windrow, install the
clevis pin on the outboard side of the draper
header support.
4. Secure clevis pin (C) with hairpin (D).
5. Repeat Step
2, page 177
remaining draper header support.
262170
to Step
4, page 177
to install the
OPERATION
B
Figure 4.112: Draper Header Supports
Figure 4.113: Draper Header Support
Figure 4.114: Draper Header Support
177
A
C
C
B
A
B
C
A
D
Revision A
Advertisement
Table of Contents
Troubleshooting
