MacDon M2170 Operator's Manual page 262

9. For grass seed headers (GSS), connect the additional four
hoses supplied with the grass seed version of the header as
follows:
a. Connect the hose with the green cable tie with female
quick coupler (A) to coupler (B) on the
windrower frame.
b. Connect the hose with the yellow cable tie with male
quick coupler (C) to coupler (D) on the
windrower frame.
c. Remove the cap (not shown) from inboard bulkhead
fitting (E). Connect hose (F) (red cable tie) to inboard
bulkhead fitting (E).
NOTE:
The other end of hose (F) connects to the grass seed
module's drum on the left side of the header.
d. Remove the cap (not shown) from outboard bulkhead
fitting (G). Connect hose (H) (blue cable tie) to
outboard bulkhead fitting (G).
NOTE:
The other end of hose (H) connects to the grass seed
module's drum on the right side of the header.
10. Free electrical harness (A) from adjustable strap (B).
262170
OPERATION
Figure 4.244: Grass Seed Hydraulic Connections –
Auger/Rotary Disc/Draper—Ready Configuration
Figure 4.245: Electrical Harness Secured to Center-Link
238
D
B
C
A
E
F
G
H
B
A
Revision A