YASKAWA GA800 Technical Reference page 1036

12.11 o: Keypad-Related Settings
A - Set Ux-xx [Monitors] (Monitor 1) to o1-24.
B - Set Ux-xx [Monitors] (Monitor 2) to o1-25.
C - Set the maximum value of Monitor 2 to o1-50.
D - Set the minimum value of Monitor 2 to o1-49.
■
o1-01: User Monitor Selection
No.
Name
(Hex.)
o1-01 User Monitor Selection
(0500)
RUN
When the drive is in Drive Mode, push
rotational direction → output frequency → output current → o1-01 selection.
Set the x-xx part of Ux-xx that is shown in the fifth position in Drive Mode. For example, to show U1-05 [Motor
Speed], set o1-01 = 105.
Note:
The monitors that you can select are different for different control methods.
■
o1-02: Monitor Selection at Power-up
No.
Name
(Hex.)
o1-02 Monitor Selection at Power-
up
(0501)
RUN
1 : Frequency Reference (U1-01)
2 : Direction
3 : Output Frequency (U1-02)
4 : Output Current (U1-03)
5 : User Monitor (o1-01)
Shows the monitor item selected in o1-01 [User Monitor Selection].
■
o1-03: Frequency Display Unit Selection
No.
Name
(Hex.)
o1-03 Frequency Display Unit
Selection
(0502)
1036
G
F
Figure 12.148 Trend Plot Display
V/f CL-V/f OLV CLV AOLV
Sets the U monitor for the Drive Mode. This parameter is only available with an LED keypad.
on the keypad to cycle through this data: frequency reference →
V/f CL-V/f OLV CLV AOLV
Sets the monitor item that the keypad screen shows after you energize the drive. Refer to "U:
Monitors" for information about the monitor items that the keypad screen can show. This parameter is
only available with an LED keypad.
V/f CL-V/f OLV CLV AOLV
Sets the display units for the frequency reference and output frequency.
E - Set the time scale to o1-51.
F - Set the minimum value of Monitor 1 to o1-47.
G - Set the maximum value of Monitor 1 to o1-48.
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Default
(Range)
106
(104 - 855)
Default
(Range)
1
(1 - 5)
Default
(Range)
Determined by A1-02
(0 - 3)