Delta AS Series Programming Manual page 245

A S S er i es Pr og r am m ing M an u a l

Use the following instructions with the Ladder Programming Language
For the following instructions, you need to start the instruction execution while the PLC switch from STOP to RUN.
And when the following instructions stop executing, the PLC should stop programming too. It is suggested to use
the following instructions with the Ladder Programming Language. Do NOT use the programming language that
only does one time execution, for example, function blocks that only can be called once. Or do not use the
programming language that stops scanning once the executing the instruction stops, for example ST and SFC
programming languages. If the function block can be called several times by different programs, it is not suitable
for the following instructions either.
Type of Instruction
Timer and Counter
Instructions
Peripheral
Instructions
Miscellaneous
Instruction
Module Instructions
_4
CANopen
Communication
Instructions
Memory Card / File
Register Instructions
Communication
Instructions
Other Instructions
4 - 8
CNT, DCNT, DHSCS, DHSCR, DHSZ, DHSCY
TKY, DTKY, HKY, DHKY, DSW, ARWS
RAMP, DRAMP, MTR, INCD
DPUCONF, PUSTAT
COPRW, COPWL, DCOPWL, ZRNM, ECAMD, ECAMS, ECAMA, ECAMC
MEMW
DNETRW
INFO
Instructions