Show Serial Status And Statistics - Digi IX14 User Manual

3. Set the type of parity used by the device to which you want to connect:
(config)>path-paramparity parity
(config)>
Allowed values are:
even
n
odd
n
none
n
The default is none.
4. Set the stop bits used by the device to which you want to connect:
(config)>path-paramstopbits bits
(config)>
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show serial status and statistics

To show the status and statistics for the serial port:

WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Connections, click Serial.

Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show serial
> show serial
Label
--------
Serial 1
>
IX14 User Guide
command:
Port Enable Mode
----- ------ -----
port1 true login
Baudrate
--------
115000
Serial port
171