Table of Contents
Advertisement
12 Configuration by the operator
12.8 Carrying out a software update
Requirement
304
EN
MEDUCORE Standard
•
A charged battery is inserted in the device.
•
The device is connected to line power.
•
The device is switched off and an SD card with new software is
in the SD card slot.
Risk of injury due to lack of function check after software
update!
If no function check is carried out following a software update,
errors occurring during the software update may go undetected.
This may cause the patient or the user serious or life-threatening
injury.
Carry out a function check after every software update.
Failure of therapy due to failure of the battery and lack of line
power!
If the power supply to the device is cut during the software update
due to a battery failure and lack of line power, the device may be
damaged to such an extent that it needs to be repaired.
Always connect the device to line power with a charged battery
for software updates.
1. If the software is provided as a ZIP file: Unzip the software.
2. Place the file in the SD card's root directory.
When doing so, please note: The file must not be in a
sub-folder.
3. Activate the operator menu
menu", page
307).
4. Select System settings | Software update.
5. Select new software with the navigation knob.
6. Run the software update with the Start function button.
7. Wait until the software update has finished.
After the end of the software update, the device displays the
message SUCCESS.
8. Restart the device with the Restart function button.
The device restarts.
2
(see "13.1 Activating the operator
Advertisement
Table of Contents
