Table of Contents
Advertisement
11.2 Alarm messages
11.2.1 High-priority alarm (red)
Alarm
Asystole
Battery defective
Battery empty
Check defibrillation
electrodes
(Manual mode)
Check patient contact
Defibrillation module
defective
Insert battery
(Manual mode)
Plug in Pad connector
(Manual mode)
Shock not successful
(Manual mode)
Cause
Asystole detected
Battery defective
Very low battery status
Defibrillation electrodes no longer
attached/not attached correctly to
the patient
Paddles are not in contact/not
correctly in contact with the
patient
Internal defibrillation module
defective
Battery not inserted/not inserted
correctly
Defibrillation electrodes not
connected/not connected correctly
to the master cable
Paddles not connected/not
connected correctly to the master
cable
Master cable not connected/not
connected correctly to the device
No patient contact during shock
delivery
11 Alarms and faults
Remedy
Act in accordance with currently
applicable guidelines.
If medically indicated, carry out
suitable treatment.
Let the device run on battery
power without line power until it
switches off. Fully recharge battery
(see 4.4.2, p.
continues to display the alarm:
Change battery
Change battery
Connect device to line power
4.3, p. 83)
and charge battery
4.4.2, p.
86).
Attach defibrillation electrodes to
the patient correctly
122).
Check contact between paddles
and patient. If the alarm persists:
Cancel shock delivery.
Have the device repaired.
Insert battery correctly
83).
Connect defibrillation electrodes
to the master cable correctly
6.5.1, p.
122).
Connect paddles to the master
cable correctly
Connect the master cable to the
device correctly
Wait 10 seconds.
Charge the shock capacitor again
using the Charge function button.
MEDUCORE Standard
86). If the device
(see 4.4.4, p.
88).
(see 4.4.4, p.
88).
(see
(see
(see 6.5.1, p.
(see 4.3, p.
(see
(see 6.5.2, p.
126).
(see 6.5.1, p.
122).
2
EN
271
Advertisement
Table of Contents
