Table of Contents
Advertisement
8.4 Software Update
In this menu you can load the latest software version to the
device.
To install the latest software version, proceed as follows:
1. Save the latest software version on a USB stick.
Caution!
Only USB sticks which conform to the USB standard 2.0
should be inserted in the USB port. Otherwise the oper-
ation of the unit might be disrupted, putting the patient
at risk.
Notice:
Ensure that the battery of the MEDUMAT Trans-
port is at least 50% charged or that the device is
connected up to the power supply. Otherwise the
update will not start and the following message
appears: "Battery capacity < 50%! To perform an
update, please connect device to power supply."
We recommend always connecting the device to
the power supply before performing an update.
2. Switch on the device.
3. Insert a USB stick in the USB port of the device.
4. Select the "Software Update" page in the operator
menu.
Notice:
It can take a moment for the MEDUMAT Transport
to detect the USB stick.
Leave the USB stick in the device's USB port
throughout the software update. Do not remove it
until the software update has completely finished.
Operator menu
EN
103
Advertisement
Table of Contents
