Table of Contents
Advertisement
3. Disassemble the pulse oximetry sensor and pulse oximetry
4. Disassemble the ECG cable
5. Disassemble the NIBP cuff and NIBP connecting tube
6. Remove the remaining accessories from the device.
7. In the event of contamination or suspected contamination of
8. Dispose of all disposables properly
Result
All parts have been prepared for hygienic reprocessing.
8.3 Cleaning parts manually
Requirement
•
•
1. For parts approved for cleaning, refer to the cleaning and
2. For the agents, dose, and exposure time for the individual
sensor connecting cable
oximetry sensor and pulse oximetry sensor connecting cable",
page
222).
cable", page
224).
Disassembling the NIBP cuff and NIBP connecting tube",
page
225).
inaccessible areas of the device, protective transport bag or
portable unit: Disassemble the device from the protective
transport bag and retaining plate
device from the protective transport bag and the retaining
plate", page
227).
Alternatively:
Disassemble the device from the portable unit
Disassembling the device from the portable unit", page
When doing so, please note: Disassembly is described in the
instructions for use of the portable unit.
page
357).
The parts exhibit visible dirt.
Hygienic reprocessing is prepared
reprocessing", page
disinfection plan
(see "8.7 Cleaning and disinfection plan",
page
240).
parts, refer to the cleaning and disinfection plan.
8 Hygienic reprocessing
(see "7.3 Disassembling pulse
(see "7.4 Disassembling ECG
(see "7.6 Disassembling the
(see "16 Disposal",
(see "8.2 Preparing hygienic
232).
MEDUCORE Standard
(see "7.5
(see "7.7
229).
2
EN
233
Advertisement
Table of Contents
