Ike Client Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
IKE C C
LIENT OMMAND
To activate the IKE Client mode, enter the crypto ike client command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#crypto ike client configuration pool ConfigPool1
(config-ike-client-pool)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
dns-server <address1> <address2>
ip-range <start ip> <end ip>
netbios-name-server <address1> <address2>
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.
61200510L1-35E
S
ET
on page 1251
on page 1252
on page 1253
Copyright © 2005 ADTRAN

IKE Client Command Set

1250