Bosch Rexroth IndraDrive Troubleshooting Manual page 419

Hide thumbs Also See for Rexroth IndraDrive:
Table of Contents

Advertisement

13-2
Index
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Cam shaft, encoder 2, virtual master axis 6-22
Cam shaft, lagless, encoder 1, real master axis 6-25
Cam shaft, lagless, encoder 1, virt. master axis 6-24
Cam shaft, lagless, encoder 2, real master axis 6-25
Cam shaft, lagless, encoder 2, virt. master axis 6-24
charg 5-2
Class 1 diagnostics error at command start 9-91
Command Abrasion of brake 9-16
Command Apply motor holding brake 9-16
Command automatic control loop setting 9-9
Command Calculate data for asynchronous motor 9-14
Command Determine encoder correction 9-15
Command Firmware update from MMC 9-13
Command Get marker position 9-8
Command measuring wheel mode 9-8
Command not enabled 9-98
Command only possible in 'bb' 9-86
Command only possible with linear synchronous motor 9-85
Command Release motor holding brake 9-10
Command Set absolute measuring 9-2
commands
command types 1-18
commissioning
after a fatal error (F8xxx errors) 7-5
after a fatal system error (F9xxx or E-xxxx errors) 7-1
after a interface error (F4xxx error) 7-49
after a non-fatal error (F2xxx error) 7-75
after a non-fatal safety technology error (F3xxx error) 7-57
after a safety technology error (F7xxx-error) 7-29
after a travel range error (F6xxx error) 7-41
Communication phase 0 6-1
Communication phase 1 6-2
Communication phase 2 6-3
Communication phase 3 6-4
Communication phase 3 transition check 9-1
Communication phase 4 transition check 9-1
Commutation determination not selected 9-86
Commutation offset could not be determined 7-7
Commutation offset could not be determined. 9-84
Commutation offset invalid 7-113
commutation offset setting 9-7
Commutation offset setting command 9-7
Config. IDN for MDT not configurable 9-19
Config. IDNs for AT not configurable 9-20
Control and power sections ready for operation 6-6
control panel 1-9
control parameters 1-9
Control section defective 7-21
Copy IDN from internal memory to optional memory 9-12
Copy IDN from optional memory to internal memory 9-11
Correction value table cannot be stored 9-119
Current limit active 8-6
Current measurement trim wrong 7-107
D
Default parameters invalid 9-75
Default parameters not available 9-74
Determining travel range only via travel distance 9-97
Device overload prewarning 8-33
Device overload, current limit active 8-11
Device overtemp. Prewarning 8-25
Device overtemperature 2 prewarning 8-21
Device overtemperature 2 shutdown 7-93
Device overtemperature shutdown 7-83
Device temperature monitor defective 7-85
diagnostic drive messages 1-1
diagnostic message
display 1-3
error number 1-4
Rexroth IndraDrive
DOK-INDRV*-GEN-**VRS**-WA01-EN-P

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents