Xx:f8122; Xx:f8129; Xx:f8130; Xx:f8120 - Bosch Rexroth IndraDrive Troubleshooting Manual
Hide thumbs
Also See for Rexroth IndraDrive:
- Applications manual (100 pages) ,
- Project planning manual (128 pages) ,
- Instruction manual (26 pages)
Table of Contents
Advertisement
Rexroth IndraDrive
XX:F8122
Cause
Hardware of control section is defective
XX:F8129
XX:F8130
XX:F8120
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Handling, Diagnostic and Service Functions
Brief Description: Error: control section defective
An error occurred during firmware update.
Remedy
Replace control section or entire drive controller; use
hardware configuration of same type
Note:
Only Rexroth service engineers or especially trained users are
allowed to replace the control section. The replacement of the
entire drive controller is described in the Project Planning
Manual for the power section.
Identical cause / remedy: F8122 Control section defective
Brief
Description:
Error:
programmed
See F8129 Firmware of option 1 of safety technology defective
Brief
Description:
Error:
programmed
See F8130 Firmware of option 2 of safety technology defective
Brief Description: Error: firmware does not support hardware
See F8120 Invalid control section/firmware combination
optional
safety
module
optional
safety
module
10-5
1
incorrectly
2
incorrectly
- Quick Links:
- Coded Diagnostic Drive Messages
- Error
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Rexroth IndraDrive and is the answer not in the manual?
Questions and answers
Our machine in Rexroth drive installation total 20 nos machine so facing issue shortly 5 drive folty 8060 erro so how to do
Error 8060 on Bosch Rexroth IndraDrive indicates an overcurrent in the power section. To resolve this issue for five machines, follow these steps for each machine:
1. Check the Load and Connections – Verify that the motor and power connections are correct and not causing excessive current draw.
2. Inspect the Power Section – Look for any visible damage or overheating signs in the power section.
3. Restart the System – Power off the drive, wait for the DC bus to discharge below 50V, and restart.
4. Adjust Parameters if Needed – Ensure that the drive’s current limits and motor settings are correctly configured.
5. Replace Faulty Components – If the issue persists, the power section may be defective and require replacement.
Repeat these steps for all five machines to ensure proper operation.
This answer is automatically generated