F8129 Firmware Of Option 1 Of Safety Technology Defective - Bosch Rexroth IndraDrive Troubleshooting Manual

7-22
Error Messages

F8129 Firmware of option 1 of safety technology defective

Cause
Programming of firmware for optional safety
technology module is invalid
An error occurred during firmware update
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Supported by Firmware Variant:
The firmware of the optional safety technology module is defective.
Remedy
Make firmware update
Restart firmware update.
If error message is displayed again, replace control
section with control section of same type, if you are
authorized to do this! Otherwise entire drive controller
has to be replaced.
Note: Only Rexroth service engineers or especially trained users are
allowed to replace the control section. The replacement of the
entire drive controller is described in the Project Planning
Manual for the power section.
F8129 - Attributes
Display: F8129
Mess. no.: F8129 (hex)
Rexroth IndraDrive
FWA-INDRV*-MPH02VRS-MS
FWA-INDRV*-MPB02VRS-MS
FWA-INDRV*-MPD02VRS-MS
DOK-INDRV*-GEN-**VRS**-WA01-EN-P