F2840 Error Supply Shutdown; F2860 Overcurrent In Mains-Side Power Section; F2890 Invalid Device Code - Bosch Rexroth IndraDrive Troubleshooting Manual

Rexroth IndraDrive

F2840 Error supply shutdown

Cause
A second supply unit or converter connected in
parallel signals a supply error

F2860 Overcurrent in mains-side power section

For HCS, HMS, HMD
For HMV01.1R
Cause
Short circuit in motor or motor cable
Device defective
Current loop parameterized differently (not for
HMV01.1R)

F2890 Invalid device code

Cause
Device defective
DOK-INDRV*-GEN-**VRS**-WA01-EN-P
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Supported by Supply Unit:
Remedy
Remove cause of error at respective supply unit /
converter and clear error
F2840 - Attributes
Display: F2840
Mess. no.: F2840 (hex)
Supported by Supply Unit:
The current in the power transistor bridge has exceeded the maximum
allowed device peak current. The drive is immediately de-energized, the
motor coasts to stop.
The current in the mains-side power bridge has exceeded the maximum
allowed value. The power supply is switched off.
Remedy
Check motor cable and motor for short circuit
Replace device
Check current loop parameters to see whether they
differ from the parameters on the motor data sheet;
correct them if necessary
F2860 - Attributes
Display: F2860
Mess. no.: F2860 (hex)
Supported by Supply Unit:
Remedy
Replace device
F2890 - Attributes
Display: F2890
Mess. no.: F2890 (hex)
Error Messages
HMV01
HMV01
HMV01
7-127