Xx:erase; Xx: Prog; Xx: Cks; Xx:e Adr - Bosch Rexroth IndraDrive Troubleshooting Manual

Hide thumbs Also See for Rexroth IndraDrive:
Table of Contents

Advertisement

10-2
Handling, Diagnostic and Service Functions

XX:ERASE

XX: PROG

XX: CKS

XX:E ADR

Cause
Address read from IBF file is outside of allowed
range

XX:E SEC

Cause
Data in IBF concerning memory range (firmware,
loader, boot kernel) are incorrect
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Brief Description: Clearing active
The loader (FL:ERASE = firmware loader, LD:ERASE = loader in control
section) is in the clearing mode. The requested memory range / module is
being cleared.
Brief Description: Programming active
The loader (FL:PROG = firmware loader, LD:PROG = loader in control
section) is in the programming mode. The transmitted data are written to
the requested address in the memory range / module.
Brief Description: Checksum calculation active
The checksum calculation is active. Subsequent to the calculation a
comparison with the stored checksums is run.
Note:
"FL: CKS" means firmware loader and "LD: CKS" means
loader in control section.
Brief Description: Warning: address error
Remedy
Please contact our service department
Note:
"FL:E ADR" means firmware loader and "LD:E ADR" means
loader in control section.
Brief Description: Warning: range error
Remedy
Please contact our service department
Note:
"FL: SEC" means firmware loader and "LD: SEC" means
loader in control section.
Rexroth IndraDrive
DOK-INDRV*-GEN-**VRS**-WA01-EN-P

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF