Offset Placement After Solder Screen-Printing Light (Optional); Replacing The Offset Placement After Solder Screen-Printing Light - JUKI KE-3010 Maintenance Manual

DANGER
[17] OFFSET PLACEMENT AFTER SOLDER SCREEN-PRINTING LIGHT
(OPTIONAL)

17-1. Replacing the Offset Placement after Solder Screen-Printing Light

1) Unscrew the low head cap screws and remove the board spacer, prism base and the OCC
angle light board.
2) Reassemble the components in reverse order.
3) After replacing the Offset Placement After Solder Screen-Printing light with a new one, it is
necessary to adjust both the Offset Placement After Solder Screen-Printing light and the OCC
light. (See 4-7. "List of Readjustment Items After Replacement".)
HX00354000D
Board stud (x 4)
40001982
OCC angle light board
40014043
PRISM BASE
Figure 17-1 Replacing the Offset Placement After Solder Screen-Printing Light
Maintenance Guide
To prevent any trouble caused by accidental machine start, always
shut-down the power before starting the maintenance and
adjustment work.
17-1
HX00335000G
Board spacer (x 4)
40032433
Low head cap screw
M3 x 10 (x 4)
Rev. 2.0