JUKI KE-3010 Maintenance Manual page 243

Adjusting the feeder float sensor outside the mecha/machine
1) Set the bulk feeder at the left, center, and right positions of the bank to check that the
sensor is not turned OFF.
2) Set the NF32 feeder at the same positions as described in step 1) and open the top cover
by hand to check that the sensor is turned OFF when the top cover is raised 10 mm or
less.
Figure 12-2-3 Adjusting the Feeder Float Sensor
3) Set the NF16 feeder at the same positions as described in step 1) and open the top cover
using the lever to check that the sensor is turned OFF.
Figure 12-2-4 Adjusting the Feeder Float Sensor
Maintenance Guide
NF32 feeder
Top cover
N16 feeder
12-10
Raise the cover by hand.
Lever
Rev. 2.0