Replacing The Push-Button Switch (Machine With The En Specifications) - JUKI KE-3010 Maintenance Manual

11-1-2. Replacing the Push-Button Switch (Machine with the EN Specifications)

1 2
5
6
1
5
1) Detach the whole operation unit from the machine main unit. (M4 hexagon screws at 4
locations)
2) Detach the switch panel cover. (M3 hexagon screws at 4 locations)
3) Detach the operation board.
4) To detach the switch, remove the base part (mounting nut) of the switch from the rear of the
cover and pull out the case from the cover front. Then replace the switch.
5) Reassemble the components in the reverse order of disassembly.
Back of Cover
CAUTION
A combination of the switch connector and connector on the operation switch board has
a specified orientation. Always pay special attention to the orientation when mounting
the switch.
Maintenance Guide
3
4
7 8 9
3 4
8 9
Pull out
Front
Rear
Panel
Mounting
Case
nut
Groove
Stop metal fitting
Edge
Detachment of Switch
11-3
Rev. 2.0
Feeder switch
(Provided when non-stop
operation is mounted.)
Laser ON lamp
(Provided when the optional
coplanarity is mounted.)
On-line switch
Start switch
Keyboard setting switch
(Provided when rear
operation is mounted.)
Key switch
Origin switch
Stop switch
Single cycle switch
Turn
Turn