Adjusting The Focus - JUKI KE-3010 Maintenance Manual

4-5. Adjusting the Focus

<Procedure>
1) Mount the camera adjustment jig on the top of the CAL block so that the etching surface is
faced downward.
2) Loosen the SEMS cap bolt with washers
camera, move the camera up and down, and when lines up to 2 on the etching surface are
clearly visible (see the figure below), secure the camera in position.
When the polarizing filter is adjusted to the scale "0" (dark) position, the lines can be seen
easily.
After the adjustment has been completed, return the polarizing filter to the scale "5" (bright)
position.
「2」まわりの線がはっきり
Maintenance Guide
The lines around "2"
見えること。
shall be seen clearly.
and (total of 6 locations) that secure the
SM6020302UZ (×2)
SL6041692TN
(×4)
カメラアジャスト治具
Camera
E2106998000
adjustment jig
（T110） E2106998000
(T110)
4-6
Rev. 2.0
Calibration block