Replacing And Adjusting The Feeder Float Sensor; Replacing The Sensor And Adjusting The Height - JUKI KE-3010 Maintenance Manual

DANGER

[12] REPLACING AND ADJUSTING THE FEEDER FLOAT SENSOR

12-1. Replacing the Sensor and Adjusting the Height

1) In the KE-3010/3020V/3020VR, the sensors are arranged as shown in the Figure below.
If the sensor has been replaced, the height adjustment is needed.
Reflector
⑥
40110010 Emitting
40110007 Receiving
③
40110004 Emitting
40110003 Receiving
①
40110000 Emitting
40110009 Receiving
⑦
40110012 Emitting
Maintenance Guide
To prevent any trouble caused by accidental machine start, always
shut-down the power before starting the maintenance and
adjustment work.
Rear
ETF incorrect
insertion detection
Feeder float (ETF)
Feeder float
(Mechanical, outside)
Feeder float
(Mechanical, inside)
Feeder float
(Mechanical, inside)
Feeder float
(Mechanical, outside)
Feeder float (ETF)
ETF incorrect
insertion detection
Front
Figure 12-1-1
12-1
Emitting 40093803
Receiving 40110011
Emitting 40110006
Receiving 40110005
Emitting 40110002
Receiving 40110001
Emitting 40110008
Receiving 40110013
Rev. 2.0
④
②
⑤