JUKI KE-3010 Maintenance Manual page 293

7) Update the C-drive of the coplanarity CPU board.
Run the command prompt and input "ewfmgr
Press the Enter key.
From the [Start] menu, shut down the coplanarity CPU board.
At this time, be careful not to turn OFF the power to the mounter.
DANGER
8) Change the change-over switch on the coplanarity monitor change-over PCB (40097434) in
the direction indicated by an arrow.
Maintenance Guide
The C-drive of the coplanarity CPU board is not updated unless the
coplanarity CPU board is shut down. So, be sure to shut down the
coplanarity CPU board from the [Start] menu.
Be careful not to turn OFF the power to the mounter since the
mounter software is running.
13-48
C: -commit ( expresses a space)".
̺ ̺ ̺
Rev. 2.0