JUKI KE-3010 Maintenance Manual page 232

[Assembly]
1) Assemble the SC_LOCK unit
2) At this time, adjust the clearance between the square hole in the main unit cover and the
bottom of the SCL_HOOK
3) Close the safety cover and turn ON the power to the machine main unit.
4) On the operation screen, select [Manual Control] → [Simple Control] (unit 1_cover lock) to
turn ON the lock of the safety cover.
5) With the safety cover lock turned ON, raise the safety cover upward twice or three times.
According to the conditions shown below, move to relevant step.
a) The safety cover is locked and the cover open switch is not detected. → Go to step 6).
b) The safety cover is locked, but the cover open switch is detected.
c) The safety cover is not locked, but the cover open switch is detected. → Go to step 9).
6) The adjustment is completed.
Turn OFF the lock of the safety cover through the operation screen.
7) Assemble the COVER
Maintenance Guide
with the M6×12 SEMS cap bolts
to 1 to 2 mm.
with the M4×10 SEMS cap bolts
11-7
(2 pcs.).
SCL_HOOK
1 to 2mm
→ Go to step 8).
(2 pcs.).
Rev. 2.0