Y Cableveyor Structure And Part Names; Detaching The Arm And Lock Stay - JUKI KE-3010 Maintenance Manual

1-7-6. Y Cableveyor Structure and Part Names

Part No./Part name:
40110452 Y_CABLE_BEAR_M
Part No./Part name:
40111993 Y_CABLE_BEAR_L

1-7-7. Detaching the Arm and Lock Stay

Follow the steps below to detach the arm and lock stay.
∗ Wear cotton gloves since the geralyn (white cream) is sticking to the cable inside the
cableveyor.
Detaching the arm
1) Insert a slotted screwdriver into
the clearance between the arm
lock claw and link (see the
Figure below) and turn it to float
up the lock claw on one side.
Note) Use a slotted screwdriver with a tip blade width of 4 mm or less.
Maintenance Guide
Bracket at movement end
Arm
Link
Lock stay
Bracket at fixed end
2) In the same manner as
described in step 1), turn the
slotted screwdriver toward the
opposite side to float up the
arm.
1-54
Cross separator
3) Turn the arm 90° (so that the
lock claw is located at the top)
and pull it out horizontally. The
arm is then detached.
Rev. 2.0