Rev. 2.0
Maintenance Guide
16-2. Detaching the FPI (Rear) (M and L Board Specifications)
When viewed from the rear of the machine, the FPI (rear) is secured to the FPI bracket with the
SEMS cap bolts (M6 × 12) that is secured to the feeder float sensor bracket as shown in the
Figure below.
To detach the FPI, remove the two screws and slide it upward.
When reassembling, take care not to select a wrong hole. (See Fig. below.)
SEMS cap bolt
FPI unit R
SEMS cap bolt
Assembly hole in FPI unit R
Figure 16-2-1
16-2