DANGER
[8]
VCS
8-1.
Replacing the CCD Camera Lens
(Replace the CCD Camera and Lens as S-VCS Camera Assembly.)
1) Remove the nylatches of the light unit cover to detach the front and rear flat plate V.
2) Remove the cable clamp
unit.
Additionally, if the machine is equipped with the optional VCS, disconnect the piping of the
change-over air cylinder, as well as the connector of the change-over sensor.
3) Remove the light unit set bolts
Cable clamp
Maintenance Guide
To prevent any trouble caused by accidental machine start, always
shut-down the power before starting the maintenance and
adjustment work.
on the rear to disconnect the power cable connector of the light
(4 locations) to detach the light unit.
Flat plate V
Figure 8-1-1
Nylatch
SL6051492TN
M5 × 12 SEMS cap bolts
8-1
Rev. 2.0
× 4