JUKI KE-3010 Maintenance Manual page 287

<XL board specifications>
1) When replacing the load cell 1, first remove the screws (SL6031092TN M3 × 10)
the reflection plate
the load cell mounting screws (SL6041092TN M4 × 10) 2, and then remove these screws. (It
is not necessary to detach the feeder float sensor mounting bracket
2) Disconnect all the cables 6. Remove the screws 7 (2 pcs.) from the rear of the load cell 1
and pull out the load cell amplifier from the bracket.
3) Reassemble the parts and components in the reverse order of disassembly.
Maintenance Guide
for the electric feeder incorrect detection sensor so as to get access to
1
2
6
13-42
.)
7
Assemble the components so
that the bottom of the reflection
plate is flush with the bottom
of the bracket
Rev. 2.0
to detach
.