JUKI KE-3010 Maintenance Manual page 102

(8) Reciprocate the Head several times again until the X_AXIS_FRAME_ASM is in contact with
both the Y_STOPPER on the front and the Y_STOPPER on the rear to check that the
movement is smooth.
If the movement is not smooth, make the adjustment again from step 1-9-4 (5).
(9) Secure the YL and YR coupling screws. (Tightening torque = 7[N･m])
Y_MOTOR
Coupling_Y
(10) Connect the Y_MOTOR encoder cable that has been disconnected in step 1-9-1 (8).
(11) Readjust the home position rough adjustment and check the operation.
1) Turn ON the power to the machine main unit and perform the home position rough
adjustment.
2) Turn OFF the power to the machine main unit, and then turn it ON again. After that, check
that the machine units return to their home positions.
Maintenance Guide
Coupling screw
1-91
Connect the connector.
Rev. 2.0