Replacing The Filter; Replacing The Filter For Release To Atmosphere - JUKI KE-3010 Maintenance Manual

3-1-2. Replacing the Filter

• Replacing the head filter
1) Follow step 1) described in section 3-1-1 to detach the head left cover.
2) Remove the cap bolts
(O-ring is mounted under the filter box U. Carefully handle this O-ring so that it is not lost.)
3) Take out the filter and replace it with a new one.
4) Reassemble the parts and components in the reverse order of disassembly.
5) After the filter has been replaced, check the filter through the head vacuum and the blow
ON/OFF of the manual control.

3-1-3. Replacing the Filter for Release to Atmosphere

1) Follow steps 1) and 2) described in section 3-1-1 to detach the head left cover and head
cover.
2) Loosen the SEMS cap bolts
(You can detach the filter only by loosening the SEMS cap bolts.)
3) Reassemble the parts and components in the reverse order of disassembly.
∗
SEMS cap bolts
cap (×2)
SEMS cap bolt (×2)
SEMS cap bolt (×4)
Maintenance Guide
(×2) to detach the filter box U.
(×2) to detach the filter for release to atmosphere.
(2 pcs.) are accessory parts supplied with the solenoid valve.
Figure 3-1-3-1 Replacing the Head Filter
3-2
Rev. 1.0
Head filter
Filter for release
to atmosphere