Replacing The Stopper Cylinder - JUKI KE-3010 Maintenance Manual

5-8. Replacing the Stopper Cylinder

1) Detach the hexagon nut
2) Detach the cylinder fixing screws
3) Turn the shaft of the cylinder
4) When installing a new stopper cylinder, reassemble the components in the order of steps 3)
to 1).
Make sure that the cylinder
smoothly.
Also make sure that the distance from the end of the cylinder
connector is as shown in the figure below.
5) Adjust the opening of the speed controller.
Open the speed controller on the A side (i.e. that attached to the cylinder) one turn from
the fully closed position.
Open the speed controller on the B side two and a half turns from the fully closed
position.
6) After the components have been reassembled, supply air (0.50 MPa) to check that the
stopper cylinder moves smoothly.
27±0.2mm
Maintenance Guide
.
.
to remove the cylinder from the stopper connector
is aligned along the slot on the stopper frame and moves
Speed controller
on the A side
Figure 5-8-1
5-20
Rev. 2.0
.
to the end of the stopper
Speed controller
on the B side