JUKI KE-3010 Maintenance Manual page 23

<XL board specifications>
With the Y-axis magnescale affixing jig (40094363) put tightly in contact with the side
surface of the LM guide Y and the top of the Y-axis, make the magnescale in contact with
the Y-axis magnescale affixing jig to affix the magnescale.
The Y-axis magnescale affixing start position is a position where the distance between the
center of the reference pin and the end face of the magnescale is 19 mm.
Specification value: Magnescale affixing position (distance deviation in the horizontal
YR
Center of Z-phase marking
Figure 1-2-2-2 Y-Axis Magnescale Affixing Start Position
Figure 1-2-2-3 Y-Axis Magnescale Affixing Position
Maintenance Guide
direction to the head moving direction) ±0.1 mm
139.5±0.1
Y_LM guide
Y-axis magnescale affixing jig (Part No. 40094363)
1-12
19±0.1
The affixing position is
common to the YL and YR.
Magnescale
30±0.1
Rev. 2.0
Y_LM guide
R side of
machine