JUKI KE-3010 Maintenance Manual page 34

2) Make the adjustment so that the clearance between the Y sensor dog and the sensor
surface is 1.8 to 2.5 mm (target: 2.0 mm), and then tighten the screw. (See Figure 1-3-2-3
(M and L board specifications) Figure 1-3-2-4 (XL board specifications).)
<M and L board specifications>
Y sensor BR_F assembly
Maintenance Guide
Y sensor dog
Figure 1-3-2-3 M and L Board Specifications
1-23
Rev. 2.0
Y sensor BR_R assembly
1.8 to 2.5 (target: 2 mm)
Y sensor dog
Y sensor BR_F assembly
Y sensor BR_R assembly