Rev. 2.0
Maintenance Guide
1-6-3. Assembling the Cable
1)
Apply the grease to portions where the cables (XY veyor-cable (XY veyor-cable XL), 1394
robot cable and the optical fiber cable 7M) are put in the cableveyor, and place the cables
and air tubes in the X-axis cableveyor as shown in the figure below (figure viewed from A).
∗ Check the connector orientation and take care so that the air tubes do not become warped.
A
Figure 1-6-3-1 Head Unit (Rear Side)
1-37