JUKI KE-3010 Maintenance Manual page 160

17
Change to "RUN". Set the transport width to its maximum level and keep the
[MODE] button pressed for 3 sec. or longer.
The progress bar increases as shown on the right. After that, the main digital
indicator shows "400". This value shows a light receiving amount and may include a
slight variation.
18
Change the switch
19
Press [MODE] to display the indication shown on the right.
20
Press the [UP] or [DOWN] button to indicate the display shown on the right. Press
the [MODE] button.
21
Press the [UP] or [DOWN] button to indicate the display shown on the right. Press
the [MODE] button.
22 Change to "RUN". Press the [UP] or [DOWN] button to set the threshold value
(sub-digital indicator) to "-50P".
23
Keep [MODE] pressed for 3 sec. or longer.
When the value shown on the sub-digital indicator becomes 50% of the value shown
on the main indicator, the setting is then completed.
Main digital display (Red)
RUN indicator 1 CH (Orange)
Lock lever
Maintenance Guide
to "SET" again. Press [MODE].
RUN indicator 2 CH
(Orange)
SET/RUN change-over switch
Sub-digital display (Green)
Channel change-over switch
5-19
Rev. 2.0
Operation key