Coplanarity Sensor (Optional); Replacing The Sensor - JUKI KE-3010 Maintenance Manual

13-4. Coplanarity Sensor (Optional)

13-4-1. Replacing the Sensor

1) Remove the rear cover.
Remove the rear cover.
∗
When the tape cutter is installed optionally, detach this cutter unit.
To detach the cutter unit, follow steps (1) to (7) stated in section 18-2, Replacing the Tape
Cutter Main Unit, described in the Maintenance Guide. After the work has been completed,
reassemble the parts and components in the reverse order of disassembly.
<M and L board specifications>
Fixed bank specifications
40110750 BANK_COVER_RC
<XL board specifications>
2) Disconnect the cables.
Disconnect the cables from the lower portion of the sensor.
2 Coplanarity power cable
3 Coplanarity encoder cable
4 Coplanarity LAN cable
∗
The cables that come from the inside of the sensor do not
need to be disconnected.
3) Detach the sensor.
Loosen the sensor fixing screws 5 to detach the sensor 6.
Maintenance Guide
1
This part does not
need to be detached.
13-43
Replacement table specifications
40110757 T_BANK_COVER_RCL
40110758 T_BANK_COVER_RCR
Rev. 2.0