JUKI KE-3010 Maintenance Manual page 248

4) Next, press the [MENU] button. [+] is shown at the lower right corner
its center portion.
5) [+] is shown at the lower left corner
6) [+] is shown at the upper right corner
7) [+] is shown at the upper left corner
CAUTION
To adjust the touch panel, use finger or touch pen with a round tip.
Do not use any propelling pencil or sharp object. Always press the center portion of the
calibration point. The target is 1 mm or less.
If a position other than the mark is pressed, ERR appears after approx. 5 sec. have elapsed.
At this time, restart the adjustment from work step No. 1.
8) Finally, when "TP Calib. OK!" is shown, this means that the setting has been completed
successfully.
Completed successfully.
CAUTION
If "TP Calib. Err" appears during operation or at the end of the operation, restart the
adjustment from work step No. 1.
Maintenance Guide
of the screen. Touch its center portion.
of the screen. Touch its center portion.
of the screen. Touch its center portion.
Touch positions on monitor screen
Err display
13-3
Rev. 2.0
of the screen. Touch