JUKI KE-3010 Maintenance Manual page 378

10) Adjust the pushing pressure of the fixed cutter blade. (When using the push-pull gauge for the
adjustment, it may hinder the solenoid valve. So, remove the solenoid valve temporarily.)
Push the hatched portion of the joint bar shown in the Figure below with the push-pull gauge
and adjust the pre-pressure with the hexagon socket head cap set screw so that the peak
value is 150±10 (N).
Make the adjustment with the movable cutter blades closed. After the adjustment has been
completed, secure with the nuts.
11) Apply the alvania grease to the contact surface between the fixed cutter blade and movable
cutter blade. Wipe off the grease so that the oil film can be seen, and then open and close the
cutter blades several times. Pay special attention so that your hand is not injured when
opening or closing the cutter blades.
12) Mount the cover in the reverse order of step 3) described previously.
Mount the guide in the reverse order of steps 2) and 1) described previously.
Maintenance Guide
Hexagon socket head cap set screw
Joint bar
18-8
Rev. 2.0
SL6040892TN
SCREW M4 L=8