JUKI KE-3010 Maintenance Manual page 317

14-3-2. CPU Board (40103723)
[Functions]
This is a circuit board that controls the
equipment totally.
This circuit board is connected to other circuit
boards by the Compact PCI (hereafter
referred to as "cPCI") bus.
Additionally, SOLID STATE DRIVE 8GB
(hereafter referred to as "SSD") is mounted
on this board (M and L board specifications
only). Since the operating system is written
into this SSD, the SSD becomes a boot disk.
Therefore, when replacing only this board,
remove the SSD from the current CPU board
and mount it on a new CPU board.
CAUTION: The part No. of the CPU board (40113723) does not include any SSD.
Additionally, the SSD is mounted on the right side of the control box in the
machine with the XL board specifications. (For details about replacement
procedures by specifications, see section 13-2-1-2, Replacing the SSD.)
[Dip switch settings]
This CPU board is used with the dip switch settings made before shipment.
[Meaning of LED]
PW: Lights up when the power is supplied.
[Replacement of battery]
A backup battery is mounted on the CPU board to save the BIOS settings.
Replace the battery at reference intervals of 5 years.
After the battery has been replaced, it is necessary to set up the BIOS.
[Adjustment items after replacement]
After the CPU board has been replaced, it is necessary to set up the BIOS.
Make the settings while referring to section 13-2-2, Setting Up the BIOS.
Maintenance Guide
14-20
This Photo shows the M and L board
specifications.
Rev. 2.0