Adjusting The Tension Of The Support Table Driving Timing Belt - JUKI KE-3010 Maintenance Manual

5-14-2. Adjusting the Tension of the Support Table Driving Timing Belt

To adjust the tension of the support table driving timing belt, loosen the fixing screw of the
encoder assembly
sonic belt tension meter (manufactured by UNITTA), measure the tension at the locations shown
below, and then adjust the tension within the required range.
Values to be input to the sonic belt tension meter
Maintenance Guide
and move the assembly in the arrow direction, input the said values to the
Required range
M Board Specifications
L and XL Board Specifications
Figure 5-14-2-1
Weight = 2.5
Width = 9.0
Span = 261
45N ± 5N
①
5-28
Measuring
position
Measuring
測定位置
position
Rev. 2.0