JUKI KE-3010 Maintenance Manual page 256

22) "Exit" screen
The "Exit" screen displays the contents shown below.
Main
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
F1 Help
Esc Exit
23) Exiting the "BIOS" screen
Move the cursor to "Exit Saving Changes" with the <↑> or <↓> key and press the <ENTER>
key.
24) Confirming to exit the "BIOS" screen
Move the cursor to "Yes" with the <←> or <→> key and press the <ENTER> key.
25) When Windows starts up, select "Settings" ⇒ "Control Panel" from the "Start" menu, and
then double-click "System".
26) When "System Properties" appears, select "Hardware", and then select "Device Manager
(D)".
27) When the Device Manager screen appears as shown in the Figure below, right-click
"OX16PCI95x PCI bridge" under "Multifunction Adapters" to select "Disable".
Maintenance Guide
Phoenix TrustedCore (tm) Setup Utility
Advanced Security Boot
↑↓Select Item -/+ Change Values
Select Menu Enter Select
Figure 13-2-2-1-6 BIOS Screen (Exit)
13-11
Exit
Item Specific Help
Exit System Setup and
save your change to
CMOS.
F9 Setup Defaults
Sub-Menu F10 Save and Exit
Rev. 2.0