Occ Assembly; Replacing The Occ Assembly - JUKI KE-3010 Maintenance Manual

DANGER
[4]

OCC ASSEMBLY

4-1. Replacing the OCC Assembly

1) Remove the SEMS cap bolts
2) The camera assembly is secured with the SEMS cap bolts
The light assembly is secured with the SEMS cap bolts
Disconnect the connectors and remove the screws, and then replace the OCC assembly.
3) Reassemble the components in the reverse order of disassembly. (Apply Loctite 242 to the
SEMS cap bolts
4) After the camera assembly has been replaced, adjust the focus and input MS parameters.
After the light assembly has been replaced, adjust the OCC light.
(See section 4-7, List of Readjustment Items After Replacement.)
SL6052092TN
SEMS cap bolt with
washer M5×20
Camera bracket
SL6030892TN (×3)
∗ The Figure above shows an OCC_R (KE-3020VR) mounting example.
For the OCC_R, as the camera bracket of the KE-3020V is different from that of the
KE-3020VR, the fixing bolts
Upper: SM1030501SC (×1), Lower: SL6030892TN (×2)
For the OCC_L, the fixing bolts
Upper: SM1030501SC (×1), Lower: SM3030552TN
Maintenance Guide
To prevent any trouble caused by accidental machine start, always
shut-down the power before starting the maintenance and
adjustment work.
to detach the camera bracket.
(×2) and M4 SEMS cap bolts
Camera assembly
Figure 4-1-1 OCC Assembly
of the KE-3020V are as follows.
of the KE-3020V are as follows.
.
.
(×2).)
4-1
Rev. 2.0
Head plate
SL6041292TN
SEMS cap bolt with
washer M4×12
Light assembly