1-7-3. Separating the Link
Follow the steps below to separate the link and detach it.
1) Insert a slotted screwdriver
into the hole in the bottom of
the link (inner circumferences
side).
Note) Use a slotted screwdriver with a tip blade width of 3.5 mm or less.
1-7-4. Connecting the Cableveyor
Replace the link and follow the steps below to connect the links.
1) Detach the arms for two links
at both ends and arrange
their orientations.
Enlarged photo of
4) In the same manner, connect the links on the opposite side.
Maintenance Guide
2) Pry the slotted screwdriver in the direction indicated by an arrow
to detach the link.
2) Fit the convex part on the top
of the link into the concave
part of the adjacent link.
portion
Enlarged photo of
1-52
3) Fit the bottom of the link.
portion
Enlarged photo of
Rev. 2.0
portion