14-11. ETF Power Supply (Option for M and L Board Specifications )
14-11-1. Replacing the ETF Power Supply Unit
(Note)
Before starting this work, be sure to turn OFF the main power of the
machine.
When the ETF power supply unit needs to be replaced, follow the steps below to remove the ETF
power supply unit from the machine.
14-11-1-1. Detaching the Main Unit Power Supply Unit
(Work procedure)
1) Remove the cover.
[Fixed bank specifications]
Front side
40110749
BANK_COVER_FC
[Replacement table specifications]
40110753
T_BANK_COVER_FCL
Front side
40110754
T_BANK_COVER_FCR
∗
When the optional tape cutter is mounted, detach the cutter unit.
To detach the cutter unit, follow steps (1) to (7) described in section 18-2, "Replacing the
Tape Cutter Unit", of the MAINTENANCE GUIDE.
After the work has been completed, reassemble the parts and components in the reverse
order of disassembly.
2) Detach the rear bank board.
Bank board
assembly
Maintenance Guide
14-53
Rear side
40110750
BANK_COVER_RC
40110758
T_BANK_COVER_RCR
Rear side
40110757
T_BANK_COVER_RCL
Rev. 2.0